| PE钢丝网骨架复合管漏水怎么维修？ |
| 添加时间：2019/9/28 14:24:03 浏览次数： |
| 管道维修方法 Pipeline Maintenance Method 1、管材、管件电熔、热熔连接的接口漏水时,应切断管材,按施工要求重新对管材、钢丝网骨架复合管管件进行电熔、热熔连接。 1. When water leakage occurs at the interface between pipe and fittings, the pipe should be cut off and the composite pipe fittings of pipe and steel mesh skeleton should be re-fused and hot-fused according to the construction requirements. 2、电熔、热熔连接的管道损坏范围很小时,采用电熔套筒或改造的鞍形电熔管件修理法,将管材损坏处切断,然后用电熔套筒或改造的鞍形电熔管件连接起来。 2. The damaged area of the pipeline connected by electric melting and hot melting is very small. The damaged part of the pipeline is cut off by the repair method of electric melting sleeve or modified saddle-shaped electric melting pipe fittings, and then connected by the electric melting sleeve or the modified saddle-shaped electric melting pipe fittings. 3、电熔、热熔连接的管道损坏范围较大时,必须切除损坏管段而用新管替换,接口处可采用电熔、热熔连接或法兰连接,但最后一个焊口一定要用电熔套筒连接或法兰连接。 3. When the damage scope of the pipeline connected by electric melting and hot melting is large, the damaged pipe section must be removed and replaced by new pipe. The interface can be connected by electric melting, hot melting or flange, but the last weld must be connected by electric melting sleeve or flange. 4、钢丝网骨架复合管采用承插式橡胶圈柔性连接的管道损坏时,可将损坏的管段切除,更换新管,然后用双承管箍或活络套筒(抢修接头修补器)连接。 4. When the composite pipe of steel mesh framework is damaged by flexible connection of socket rubber rings, the damaged pipe segments can be removed and replaced, and then connected by double support pipe hoops or looper sleeves (emergency repair joint patches). 5、公称外径小于或等于63㎜的管道损坏时,可将损坏的管段切除,更换新管,钢丝网骨架复合管然后用修补器连接。 5. When a pipeline with nominal outer diameter less than or equal to 63_is damaged, the damaged segment can be removed and replaced with a new one. The steel mesh skeleton composite pipe can then be connected with a patch. |
| 上一页 不锈钢内衬在管道内壁，满足介质使用要求 |
| 下一页 内衬不锈钢复合钢管焊接过程 |
Copyright © 技术支持：遨游网络